Atkinson Dynamics AD-27 Especificaciones descargar pdf (Pagina 8)

-8-

B. UNPACKING.

 AfterunpackingtheModelAD-28LD-MV,examineitfordamage

that may have occurred in transit. If the equipment has been dam-

aged, do not attempt to install or operate it, ﬁle a claim immediately

withthecarrierstatingtheextentofthedamage.Carefullycheckall

envelopes, shipping labels and tags before removing or destroying

them.

 Beforeattemptingtoinstalltheintercom,besurethatallparts

listedintheKITCONTENTSLISThavebeensupplied.

C. KIT CONTENTS LIST.

Qty. Description Part Number

1 InstructionManual 2562445

1 Resistor,1K,1W K101216

D. MOUNTING.

CAUTION

The selection of the mounting location for the device, its con-

trols and the routing of the wiring is to be accomplished under

the direction of the facilities and the safety engineer.

The intercom is intended to be mounted on any relatively ﬂat and

rigid surface by the four mounting holes in the interior of the housing.

Figure4isadimensionaloutlinedrawingshowingthepropermount-

ingconguration.Thefourmountingholesare0.202indiameterand

aredesignedtoaccepta#10mountingscrew.Hardwareformounting

the intercom to the surface is left up to the installer. The intercom

housinghastwocombination1/2"-3/4"knockoutsinthebottom.When

installingtheconduittotheseopenings,choosingthesizeandtypeof

connector is left up to the installer.

E. ELECTRICAL CONNECTIONS.

WARNING

Donotconnectwireswhenpowerisapplied.

The intercom has two wiring compartments, one for Class I wir-

ingandthesecondforClassIIwiring.Allwiringtotheintercomis

terminatedattwopcboardmountedterminalblocksprovided.The

ACPhaseandCommon,alongwithEarthGround,arelandedina

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Sin comentarios

Atkinson Dynamics AD-27 Especificaciones Pagina 8