Atkinson Dynamics AD-27 Manual de instrucciones descargar pdf (Pagina 5)

C. KIT CONTENTS LIST.

Qty. Description Part Number

1 Instruction Manual 2561571B

D. MOUNTING.

CAUTION

The selection of the mounting location for the device, its controls, and the

routing of the wiring are to be accomplished under the direction of the

facilities and the safety engineer.

The desk set console may be placed anywhere on a flat surface within

six (6) feet of a power source. It may also be reconfigured to hang on a

wall or vertical surface. For wall mounting, remove the four (4) screws

from the corners which fasten the front PVC panel holder to the back of

the case. Carefully lift the front PVC panel holder and rotate it 180

degrees, watching so that the cables inside fit correctly. Reattach the

panel with the same screws so that when the unit is secured to the wall,

the faceplate will slope outward at the bottom and the handset will be to

the left side on the front of the enclosure. Hardware for mounting the

intercom to a surface is left up to the installer. Wherever the desk set

intercom is mounted, it must be protected from rain or other water

penetration that could cause severe damage to the internal circuits.

Refer to figures 1 and 6 for dimensions of the desk set intercom and

mounting hole locations (wall mount applications), respectively.

E. ELECTRICAL CONNECTIONS.

Plug each desk set intercom into a nearby power source. Connect the

audio inputs in parallel. Audio wires should be sized properly by a

licensed installation electrician for your specified application. Refer to

figures 2 through 5 for typical connections and additional wiring informa-

tion.

-4-

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Atkinson Dynamics AD-27 Manual de instrucciones Pagina 5